Honda CB HORNET 160R 2015 Shop Manual page 84

FUEL SYSTEM
Install the float pin through the carburetor body and float.
With the float valve seated and float arm just touching the
valve, then measure the float level using the special tool
as shown.
FLOAT LEVEL: 13.0 mm (0.51 in)
TOOL:
Carburetor float level gauge 070MJ–001–I110
The float cannot be adjusted.
Replace the float assembly if it the float level is out of
specification.
Install a new O-ring into the float chamber groove. Install
the float chamber.
Install and tighten the float chamber screws to the specified
torque.
TORQUE: 2.1 N·m (0.2 kgf·m, 1.6 lbf·ft)
5-12
FLOAT PIN
FLOAT CHAMBER
O-RING
FLOAT CHAMBER
FLOAT LEVEL
GAUGE
SCREWS