Honda CB HORNET 160R 2015 Shop Manual page 185

Lubricate the all bearings with engine oil.
Drive new bearings into the right crankcase with following
tools.
TOOLS:
Crankshaft bearing:
Driver
Attachment, 52 x 55 mm
Pilot, 30 mm
INSTALLATION
Install the crankshaft into the right crankcase.
Install the transmission.
INSTALLATION
Clean all parts in solvent and dry them thoroughly.
Apply clean engine oil to each gear teeth.
Apply molybdenum oil solution to the bushing sliding
surface to ensure initial lubrication.
Assemble all parts into their original positions.
• Check the gears for freedom of movement or rotation
on the shaft.
• Install the washers and snap rings with the chamfered
edge facing the thrust load side. Confirm the inner
side of snap rings and washer when you detect the
chamfered side.
• Do not reuse worn snap ring which could easily spin
in the groove.
• Check that the snap rings are seated in the shaft
grooves, and align their end gaps with the grooves of
the spline.
CRANKCASE/TRANSMISSION/KICKSTARTER
070GD-001I100
07NAD-P200100
07746-0040700
CRANKSHAFT
DRIVER
ATTACHMENT
BEARING
CORRECT INCORRECT
SNAP RING
11-13