Initialization Procedure - Honda CB HORNET 160R 2015 Shop Manual

IGNITION SYSTEM
REMOVAL/INSTALLATION
Remove the left side cover (page 2-3).
Remove the rubber boot.
Disconnect the throttle position sensor 3P Grey connector.
Remove the carburetor (page 5-6).
Remove the screw and throttle position sensor.
Install the throttle position sensor while aligning the groove
of the sensor with the flat of the shaft as shown.
Rotate the throttle position sensor and align the hole in the
sensor with the screw hole in the carburetor.
Install and tighten the screw.
TORQUE: 3.4 N·m (0.4 kgf·m, 2.5 lbf·ft)
Connect the throttle position sensor 3P Grey connectors.
Check the throttle operation (page 3-5)
Install the left side cover (page 2-3).
INITIALIZING PROCEDURE
• After replacing the CDI or throttle position sensor,
perform the initializing procedure.
• If tachometer needle indicate the 10,000 r/min for 5
seconds in any step of the initializing procedure, turn
the ignition switch "OFF" and repeat the procedures
from the step1.
• The initializing procedure will fail automatically, if any
step is not completed within 8 seconds.
If so, turn the ignition switch "OFF" and repeat the
procedure from the step1.
16-8
THROTTLE POSITION
SENSOR
THROTTLE POSITION
3P CONNECTOR
SENSOR RUBBER BOOT
Align
THROTTLE
POSITION
SENSOR
THROTTLE POSITION
SENSOR 3P CONNECTOR
SCREW
THROTTLE POSITION
SENSOR
SCREW