Honda CB HORNET 160R 2015 Shop Manual page 202

FRONT WHEEL/SUSPENSION/STEERING
Remove the bolts, handlebar upper holders and handlebar
from the top bridge.
INSTALLATION
Place the handlebar to the top bridge.
Place the handlebar holders with the punch marks facing
forward and install the holder bolts.
Align the punch mark on the handlebar with the mating
surface of the lower holder.
Tighten the forward bolts first, then the rear bolts.
TORQUE: 22 N.m (2.2 kgf.m, 16 lbf.ft)
Slide and Install the clutch lever bracket by aligning the
meeting surface of the bracket with the punch mark on
the handle bar.
Tighten the clutch lever bracket bolt.
Allow the Apply Honda Bond A or its equivalent to the inside surface
adhesive to dry of the grips and to the clean surface of the left handlebar.
for 1 hour before
Wait 3-5 minutes and install the grip.
using.
Rotate the grips for even application of the adhesive.
12-6
BOLTS
HANDLEBAR
PUNCH MARKS
HOLDER
Align
HANDLEBAR GRIP
HOLDER
HANDLEBAR
Align
CLUTCH LEVER
BRACKET
BOLT