Carburetor - Honda CB HORNET 160R 2015 Shop Manual

FUEL SYSTEM
Handle the SE Install the SE valve to the carburetor body.
valve lock nut
Tighten the SE valve lock nut.
with care that
TORQUE: 2.3 N·m (0.2 kgf·m, 1.7 lbf·ft)
can easily be
damaged.
After the installation, check for the smooth operation of
the choke lever.
Install the fuel tank (page 2-4).
Install the left side cover (page 2-3)

CARBURETOR

REMOVAL
Remove the fuel tank right side cover (Page 2-4).
Loosen the insulator band screw and air cleaner connecting
boot band screw.
Disconnect the SE valve (page 5-5).
Disconnect the air vent hose and the throttle sensor
3P connector (page 16-7).
Turn the fuel valve "OFF", and disconnect the fuel hose
from the carburetor.
Loosen the drain screw and drain the fuel from the float
chamber into the approved gasoline container.
Completely drain any residual fuel, tighten the drain screw
to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Disconnect the drain hose from the carburetor.
Loosen the throttle cable lock nut and disconnect the
throttle cable end from the throttle drum.
5-6
CARBURETOR
SE VALVE LOCK
NUT/ SE VALVE
30 0
BAND SCREW
SE VALVE LOCK
NUT/ SE VALVE
AIR VENT
HOSE
BAND
SCREW
0
30
CARBURETOR
DRAIN HOSE
LOCK NUT
CABLE END
7-9 mm
(0.3-0.04 in)
INSULATOR
SCREW
THROTTLE SENSOR
3P CONNECTOR
7-9 mm
(0.3-.04 in)
INSULATOR
SCREW
DRAIN SCREW
THROTTLE DRUM