Edge-Core ECS4660-28F Management Manual page 242

Hide thumbs Also See for ECS4660-28F:

Table of Contents

| VLAN Configuration

Private VLANs

Use the VLAN > Private (Configure Interface) page to set the private VLAN

interface type, and assign the interfaces to a private VLAN.

"switchport private-vlan mapping" on page 1370

"switchport private-vlan host-association" on page 1370

These parameters are displayed in the web interface:

Interface – Displays a list of ports or trunks.

Port – Port Identifier. (Range: 1-28)

Trunk – Trunk Identifier. (Range: 1-8)

Port/Trunk Mode – Sets the private VLAN port types.

Normal – The port is not assigned to a private VLAN.

Host – The port is a community port. A community port can

communicate with other ports in its own community VLAN and with

designated promiscuous port(s).

Promiscuous – A promiscuous port can communicate with all

interfaces within a private VLAN.

Primary VLAN – Conveys traffic between promiscuous ports, and

between promiscuous ports and community ports within the associated

secondary VLANs. If Port Mode is "Promiscuous," then specify the

associated primary VLAN.

Community VLAN – A community VLAN conveys traffic between

community ports, and from community ports to their designated

promiscuous ports. Set Port Mode to "Host," and then specify the

associated Community VLAN.

To configure a private VLAN port or trunk in the web interface:

Click VLAN, Private.

Select Configure Interface from the Step list.

Set the Interface type to display as Port or Trunk.

Set the Port Mode to Promiscuous.

For an interface set the Promiscuous mode, select an entry from the

Primary VLAN list.

For an interface set the Host mode, select an entry from the

Community VLAN list.

Chapters

Table of Contents