Table 5: Open Shortest Path First Commands - Edge-Core ECS4620-28P Cli Reference Manual

Chapter 50
| IP Routing Commands
Open Shortest Path First (OSPFv2)
Open Shortest Path First (OSPFv2)
.

Table 5: Open Shortest Path First Commands

Command
General Configuration
router ospf
compatible rfc1583
default-information
originate
router-id
timers spf
clear ip ospf process
Route Metrics and Summaries
area default-cost
area range
auto-cost
reference-bandwidth
default-metric
redistribute
summary-address
Area Configuration
area authentication
area nssa
area stub
area virtual-link
network area
Interface Configuration
ip ospf authentication
ip ospf authentication-key
ip ospf cost
ip ospf dead-interval
ip ospf hello-interval
ip ospf message-digest-key
Function
Enables or disables OSPFv2
Calculates summary route costs using RFC 1583 (early
OSPFv2)
Generates a default external route into an autonomous
system
Sets the router ID for this device
Configures the delay after a topology change and the hold
time between consecutive SPF calculations
Clears and restarts the OSPF routing process
Sets the cost for a default summary route sent into a stub
or NSSA
Summarizes routes advertised by an ABR
Calculates default metrics for an interface based on
bandwidth
Sets the default metric for external routes imported from
other protocols
Redistribute routes from one routing domain to another
Summarizes routes advertised by an ASBR
Enables authentication for an OSPF area
Defines a not-so-stubby that can import external routes
Defines a stubby area that cannot send or receive LSAs
Defines a virtual link from an area border routers to the
backbone
Assigns specified interface to an area
Specifies the authentication type for an interface
Assigns a simple password to be used by neighboring
routers
Specifies the cost of sending a packet on an interface
Sets the interval at which hello packets are not seen before
neighbors declare the router down
Specifies the interval between sending hello packets
Enables MD5 authentication and sets the key for an
interface
– 1002 –
Mode
GC
RC
RC
RC
RC
PE
RC
RC
RC
RC
RC
RC
RC
RC
RC
RC
RC
IC
IC
IC
IC
IC
IC