Parameters: Smart Logic Control - Danfoss VLT AutomationDrive FC 300 Programming Manual

3 Parameter descriptions

3.14 Parameters: Smart Logic Control

3.14.1 13-** Prog. Features
Smart Logic Control (SLC) is essentially a sequence of user defined actions (see par. 13-52
associated user defined event
together in pairs (states). This means that when
3
event
[1] will be evaluated and if evaluated TRUE,
evaluated as FALSE, nothing happens (in the SLC) during the current scan interval and no other
event
starts, it evaluates [0] (and only
evaluating event [1]. It is possible to programme from 1 to 20
When the last event / action
event / actions:
Starting and stopping the SLC:
Starting and stopping the SLC can be done by selecting .On [1]. or .Off [0]. in par. 13-00
event
evaluates [0]). The SLC starts when the Start Event (defined in par. 13-01
SL Controller Mode
par. 13-00
and start programming from scratch.
3.14.2 13-0* SLC Settings
Use the SLC settings to activate, deactivate and reset the Smart Logic Control sequence. The logic functions and comparators are always running in the
background, which opens for separate control of digital inputs and outputs. .
13-00 SL Controller Mode
Option:
[0] Off
[1] On
13-01 Start Event
Option:
[0] * False
[1] True
[2] Running
[3] In range
[4] On reference
176
(see par. 13-51 SL Controller Event
event
[0] is fulfilled (attains the value TRUE),
action
[1] will be executed and so on. Only one
event
[0]) each scan interval. Only when
events
has been executed, the sequence starts over again from
Stop Event
). The SLC stops when the
Function:
Disables the Smart Logic Controller.
Enables the Smart Logic Controller.
Function:
Select the boolean (TRUE or FALSE) input to activate Smart Logic Control.
False [0] enters the fixed value - FALSE
True
[1] enters the fixed value - TRUE.
Running
[2] The motor is running.
In range
[3] The motor is running within the programmed current and speed ranges set in
par. 4-50 Warning Current Low
On reference
MG.33.M8.02 - VLT
SL Controller Action
[x]) is evaluated as TRUE by the SLC. Events and
action
event
events
event
[0] is evaluated TRUE, will the SLC execute
and actions .
event [0] / action
SL Controller Mode
Start Event
) is evaluated as TRUE (provided that
Stop Event
(par. 13-02 ) is TRUE. par. 13-03
to par. 4-53 Warning Speed High
[4] The motor is running on reference.
®
is a registered Danfoss trademark
FC 300 Programming Guide
[x]) executed by the SLC when the
actions are each numbered and linked
[0] is executed. After this, the conditions of
will be evaluated at any time. If an
will be evaluated. This means that when the SLC
action
[0] and start
[0]. The illustration shows an example with three
. The SLC always starts in state 0 (where it
On
[1] is selected in
Reset SLC
resets all SLC parameters
.
event
is