Danfoss VLT AutomationDrive FC 300 Programming Manual page 43

3 Parameter descriptions
0-41 [Off] Key on LCP
Option:
[0] * Disabled
[1] * Enabled
[2] Password
3
0-42 [Auto on] Key on LCP
Option:
[0] * Disabled
[1] * Enabled
[2] Password
0-43 [Reset] Key on LCP
Option:
[0] * Disabled
[1] * Enabled
[2] Password
[7] Enabled without OFF
[8] Password without OFF
3.2.7 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the LCP.
0-50 LCP Copy
Option:
[0] * No copy
[1] All to LCP
[2] All from LCP
[3] Size indep. from LCP
[4] File from MCO to LCP
[5] File from LCP to MCO
[6] Data from DYN to LCP
[7] Data from LCP to DYN
This parameter cannot be adjusted while the motor is running.
42
Function:
Avoids accidental stop of the frequency converter.
Avoids unauthorised stop. If par. 0-41
Quick Menu Password
the password in par. 0-65
Function:
Avoid accidental start of the frequency converter in Auto mode.
Avoids unauthorised start in Auto mode. If par. 0-42
Menu, then define the password in par. 0-65
Function:
No effect when [Reset] is pressed. Avoids accidental alarm reset.
Avoids unauthorised resetting. If par. 0-43
define the password in par. 0-65 Quick Menu Password
Resets the drive without setting it in
Resets the drive without setting it in
[2]).
Function:
Copies all parameters in all set-ups from the frequency converter memory to the LCP memory.
Copies all parameters in all set-ups from the LCP memory to the frequency converter memory.
Copy only the parameters that are independent of the motor size. The latter selection can be used
to programme several frequency converters with the same function without disturbing motor data.
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide
[Off] Key on LCP is included in the Quick Menu, then define
.
[Auto on] Key on LCP
Quick Menu Password .
[Reset] Key on LCP
is included in the Quick Menu, then
.
Off mode.
Off
mode. A password is required when pressing [Reset] (see
is included in the Quick