Danfoss VLT AutomationDrive FC 300 Programming Manual page 173

3 Parameter descriptions
12-31 Net Reference
Option:
[0] * Off
[1] On
12-32 Net Control
3
Option:
[0] * Off
[1] On
12-33 CIP Revision
Option:
[0] Major version (00 - 99)
[1] Minor version (00 - 99)
12-34 CIP Product Code
Range:
1100 (FC [0 – 9999]
302) 1110
(FC 301)*
12-37 COS Inhibit Timer
Range:
[0 – 65.535 ms]
12-38 COS Filters
Range:
[[0 - 9] Filter 0 – 9 (0000 -
FFFFhex)]
3.13.5 12-8* Other Ethernet Services
12-80 FTP Server
Option:
[0] * Disable
[1] Enable
12-81 HTTP Server
Option:
[0] * Disable
[1] Enable
12-82 SMTP Service
Option:
[0] * Disable
[1] Enable
172
Function:
Read only. Displays the reference source in Instance 21/71.
Reference from the network is not active.
Reference from the network is active.
Function:
Read only. Displays the control source in Instance 21/71.
Control via the network is not active.
Control via the network is active
Function:
Read only. Displays the CIP-version of the option software.
Function:
Read only. Displays the CIP product code.
Function:
Read only Change-Of-State inhibit timer. If the option is configured for COS operation, this inhibit
timer can be configured in the Forward Open telegram to prevent that continuously changing PCD
data generates extensive network traffic. The inhibit time is in milliseconds, 0 = disabled.
Function:
Change-Of-State PCD filters. Sets up a filter mask for each word of process data when operating in
COS-mode. Single bits in the PCD's can be filtered in/out.
Function:
Disables the built-in FTP server.
Enables the built-in FTP server.
Function:
Disables the build-in HTTP (web) server.
Enables the build-in HTTP (web) server.
Function:
Disables the SMTP (e-mail) service on the option.
Enables the SMTP (e-mail) service on the option.
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide