Danfoss VLT AutomationDrive FC 300 Programming Manual page 6

FC 300 Programming Guide
Functions in group 1 have higher priority than functions in group 2.
Motor:
Motor Running
Torque generated on output shaft and speed from zero rpm to max. speed on motor.
f
JOG
Motor frequency when the jog function is activated (via digital terminals).
f
M
Motor frequency.
f
MAX
Maximum motor frequency.
f
MIN
Minimum motor frequency.
f
M,N
Rated motor frequency (nameplate data).
I
M
Motor current (actual).
I
M,N
Rated motor current (nameplate data).
n
M,N
Rated motor speed (nameplate data).
n
s
Synchronous motor speed
par s
2 × . 1 − 23 × 60
n s
=
par
. 1 − 39
P
M,N
Rated motor power (nameplate data in kW or HP).
T
M,N
Rated torque (motor).
U
M
Instantaneous motor voltage.
U
M,N
Rated motor voltage (nameplate data).
Group 1
Group 2
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
1 Introduction
Reset, Coasting stop, Reset and Coasting
stop, Quick-stop, DC braking, Stop and the
"Off" key.
Start, Pulse start, Reversing, Start reversing,
Jog and Freeze output
1
5