Danfoss VLT AutomationDrive FC 300 Programming Manual page 184

FC 300 Programming Guide
[183] Drive stopped
[185] Drive in hand mode
[186] Drive in auto mode
[187] Start command given
[190] Digital input x30 2
[191] Digital input x30 3
[192] Digital input x30 4
[193] Digital input x46 1
[194] Digital input x46 2
[195] Digital input x46 3
[196] Digital input x46 4
[197] Digital input x46 5
[198] Digital input x46 6
[199] Digital input x46 7
13-11 Comparator Operator
Array [6]
Option:
[0] <
≈ (equal)
[1] *
[2] >
[5] TRUE longer than..
[6] FALSE longer than..
[7] TRUE shorter than..
[8] FALSE shorter than..
13-12 Comparator Value
Array [6]
Range:
Application [-100000.000 - 100000.000 N/A]
dependent*
3.14.4 13-2* Timers
This parameter group consists of timer parameters.
Use the result (TRUE or FALSE) from
Logic Rule Boolean 1
par. 13-40 , par. 13-42
(i.e. Start timer 1 [29]) until the timer value entered in this parameter is elapsed. Then it becomes TRUE again.
All parameters in this parameter group are array parameters with index 0 to 2. Select index 0 to program Timer 0, select index 1 to program Timer 1,
and so on.
Drive stopped
[183] A stop command ( Jog, Stop, Qstop, Coast) is issued – and not from the SLC
itself.
Drive in hand mode
[185] High when the frequency converter is in hand mode.
Drive in auto mode
[186] High when the frequency converter is in auto mode.
Function:
Select the operator to be used in the comparison. This is an array parameter containing comparator
operators 0 to 5.
Select < [0] for the result of the evaluation to be TRUE, when the variable selected in
Comparator Operand
par. 13-10
result will be FALSE, if the variable selected in par. 13-10
fixed value in par. 13-12
Select ≈ [1] for the result of the evaluation to be TRUE, when the variable selected in
Comparator Operand
par. 13-10
Value
.
Select > [2] for the inverse logic of option < [0].
Function:
Enter the 'trigger level' for the variable that is monitored by this comparator. This is an array pa-
rameter containing comparator values 0 to 5.
timers event
directly to define an (see par. 13-51
Logic Rule Boolean 2
or par. 13-44
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
is smaller than the fixed value in par. 13-12
Comparator Operand
Comparator Value .
is approximately equal to the fixed value in par. 13-12
SL Controller Event
), or as boolean input in a
Logic Rule Boolean 3
). A timer is only FALSE when started by an action
3 Parameter descriptions
3
Comparator Value
. The
is greater than the
Comparator
logic rule
(see
183