Parameters: Smart Logic Control - Danfoss FC 300 Programming Manual

2. How to Programme
10-33 Store Always
Option:
*
Off
[0]
2
[1] On
10-39 Devicenet F Parameters
Array [1000]
No LCP access
*
0 [0 - 0]

2.14. Parameters: Smart Logic Control

2.14.1. 13-** Prog. Features
Smart Logic Control (SLC) is essentially a sequence of user defined actions (see par. 13-52 [x]) executed by the SLC when the associated user defined
event (see par. 13-51 [x]) is evaluated as TRUE by the SLC. Events and
event
when [0] is fulfilled (attains the value TRUE),
action
[1] will be executed and so on. Only one
during the current scan interval and no other
each scan interval. Only when
from 1 to 20 events and
When the last event /
event / actions:
Starting and stopping the SLC:
Starting and stopping the SLC can be done by selecting .On [1]. or .Off [0]. in par. 13-00. The SLC always starts in state 0 (where it evaluates
The SLC starts when the Start Event (defined in par. 13-01
Stop Event
stops when the
2.14.2. 13-0* SLC Settings
Use the SLC settings to activate, deactivate and reset the Smart Logic Control.
126
Function:
Deactivates non-volatile storage of data.
Stores parameter data received via DeviceNet in EEPROM non-volatile memory as default.
This parameter is used to configure the frequency converter via DeviceNet and build the EDS-file.
action
[0] is executed. After this, the conditions of
event
will be evaluated at any time. If an
events
will be evaluated. This means that when the SLC starts, it evaluates
event
[0] is evaluated TRUE, will the SLC execute
actions .
action has been executed, the sequence starts over again from
(par. 13-02) is TRUE. Par. 13-03 resets all SLC parameters and start programming from scratch.
MG.33.M3.02 - VLT
actions are each numbered and linked together in pairs (states). This means that
event
action
[0] and start evaluating
event [0] / action
Start Event
) is evaluated as TRUE (provided that
®
is a registered Danfoss trademark
FC 300 Programming Guide
event
[1] will be evaluated and if evaluated TRUE,
is evaluated as FALSE, nothing happens (in the SLC)
event
[0] (and only
event
[1]. It is possible to programme
[0]. The illustration shows an example with three
On
[1] is selected in par. 13-00). The SLC
event
[0])
event
[0]).