Danfoss VLT AutomationDrive FC 300 Programming Manual page 172

FC 300 Programming Guide
12-21 Process Data Config Write
Range:
[[0 - 9] PCD read 0 - 9]
NB!
For configuration of 2-word (32-bit) parameter read/write, use 2 consecutive arrays in par. 12-21 and 12-22.
12-22 Process Data Config Read
Range:
[[0 - 9] PCD read 0 - 9]
12-28 Store Data Values
Option:
[0] * Off
[1] Store All set-ups
12-29 Store Always
Option:
[0] * Off
[1] On
3.13.4 12-3* EtherNet/IP
12-30 Warning Parameter
Range:
[0000 – FFFF hex]
Function:
Configuration of readable process data.
Function:
Configuration of readable process data.
Function:
This parameter activates a function that stores all parameter values in the non-volatile memory
(EEPROM) thus retaining parameter values at power-down.
The parameter returns to "Off".
The store function is inactive.
All parameter value will be stored in the non-volatile memory, in all four setups.
Function:
Activates function that will always store received parameter data in non-volatile memory (EEPROM).
Function:
Read only. Displays the EtherNet/IP specific 16-bit Status-word.
Bit
0 Owned
1 Not used
2 Configured
3 Not used
4 Not used
5 Not used
6 Not used
7 Not used
8 Minor recoverable fault
9 Minor unrecoverable fault
10 Major recoverable fault
11 Major unrecoverable fault
12 Not used
13 Not used
14 Not used
15 Not used
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
3 Parameter descriptions
Description
3
171