Danfoss VLT AutomationDrive FC 300 Programming Manual page 158

FC 300 Programming Guide
9-27 Parameter Edit
Option:
[0] Disabled
[1] * Enabled
9-28 Process Control
Option:
[0] Disable
[1] * Enable cyclic master
9-44 Fault Message Counter
Range:
0* [0 - 65535 ]
9-45 Fault Code
Range:
0* [0 - 0 ]
9-47 Fault Number
Range:
0* [0 - 0 ]
9-52 Fault Situation Counter
Range:
0* [0 - 1000 ]
9-53 Profibus Warning Word
Range:
0 N/A* [0 - 65535 N/A]
Read only
Function:
Parameters can be edited via Profibus, the standard RS485 interface, or the LCP.
Disables editing via Profibus.
Enables editing via Profibus.
Function:
Process control (setting of Control Word, speed reference, and process data) is possible via either
Profibus or standard fieldbus but not both simultaneously. Local control is always possible via the
LCP. Control via process control is possible via either terminals or fieldbus depending on the settings
in par. 8-50 Coasting Select to par. 8-56
Disables process control via Profibus, and enables process control via standard fieldbus or Profibus
Master class 2.
Enables process control via Profibus Master Class 1, and disables process control via standard field-
bus or Profibus Master class 2.
Function:
This parameter displays the number of error events stored in par. 9-45
Fault Number
par. 9-47 . The maximum buffer capacity is eight error events. The buffer and counter
are set to 0 upon reset or power-up.
Function:
This buffer contains the alarm word for all alarms and warnings that have occurred since last reset
or power-up. The maximum buffer capacity is eight error events.
Function:
This buffer contains the alarm number (e.g. 2 for live zero error, 4 for mains phase loss) for all
alarms and warnings that have occurred since last reset or power-up. The maximum buffer capacity
is eight error events.
Function:
This parameter displays the number of error events which have occurred since last reset of power-
up.
Function:
This parameter displays Profibus communication warnings. Please refer to the
Instructions for further information.
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
3 Parameter descriptions
Preset Reference Select .
3
Fault Code
and
Profibus Operating
157