Danfoss VLT AutomationDrive FC 300 Programming Manual page 149

3 Parameter descriptions
8-54 Reversing Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
3
[3] * Logic OR
NB!
This parameter is only active when par. 8-01
8-55 Set-up Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
8-56 Preset Reference Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
148
Function:
Select control of the frequency converter reverse function via the terminals (digital input) and/or
via the fieldbus.
Activates the Reverse command via the serial communication port or fieldbus option.
Activates the Reverse command via the fieldbus/serial communication port, AND additionally via
one of the digital inputs.
Activates the Reverse command via the fieldbus/serial communication port OR via one of the digital
inputs.
Control Site Digital and control word
is set to [0]
Function:
Select control of the frequency converter set-up selection via the terminals (digital input) and/or via
the fieldbus.
Activates the set-up selection via a digital input.
Activates the set-up selection via the serial communication port or fieldbus option.
Activates the set-up selection via the fieldbus/serial communication port, AND additionally via one
of the digital inputs.
Activate the set-up selection via the fieldbus/serial communication port OR via one of the digital
inputs.
Control Site is set to [0] Digital and control word
Function:
Select control of the frequency converter Preset Reference selection via the terminals (digital input)
and/or via the fieldbus.
Activates Preset Reference selection via a digital input.
Activates Preset Reference selection via the serial communication port or fieldbus option.
Activates Preset Reference selection via the fieldbus/serial communication port, AND additionally
via one of the digital inputs.
Activates the Preset Reference selection via the fieldbus/serial communication port OR via one of
the digital inputs.
Control Site Digital and control word
is set to [0]
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide
.
.
.