Danfoss VLT AutomationDrive FC 300 Programming Manual page 219

3 Parameter descriptions
16-70 Pulse Output #29 [Hz]
Range:
0* [0 - 40000 ]
16-71 Relay Output [bin]
Range:
3
0 N/A* [0 - 511 N/A]
16-72 Counter A
Range:
0* [-2147483648 - 2147483647 ]
16-73 Counter B
Range:
0* [-2147483648 - 2147483647 ]
16-74 Prec. Stop Counter
Range:
0* [0 - 2147483647 ]
16-75 Analog In X30/11
Range:
0.000 N/A* [-20.000 - 20.000 N/A]
16-76 Analog In X30/12
Range:
0.000 N/A* [-20.000 - 20.000 N/A]
16-77 Analog Out X30/8 [mA]
Range:
0.000 N/A* [0.000 - 30.000 N/A]
16-78 Analog Out X45/1 [mA]
Range:
0.000* [0.000 - 30.000 ]
218
Function:
View the actual value of pulses at terminal 29 in digital output mode.
This parameter is available for FC 302 only.
Function:
View the settings of all relays.
Function:
View the present value of Counter A. Counters are useful as comparator operands, see
Comparator Operand
par. 13-10 .
The value can be reset or changed either via digital inputs (parameter group 5-1*) or by using an
SLC action (par. 13-52 SL Controller Action
Function:
View the present value of Counter B. Counters are useful as comparator operands
(par. 13-10 Comparator Operand ).
The value can be reset or changed either via digital inputs (parameter group 5-1*) or by using an
SL Controller Action
SLC action (par. 13-52
Function:
Returns the actual counter value of precise counter (par. 1-84
Function:
View the actual value at input X30/11 of MCB 101.
Function:
View the actual value at input X30/12 of MCB 101.
Function:
View the actual value at input X30/8 in mA.
Function:
View the actual value at output X45/1. The value shown reflects the selection in par. 6-70
X45/1 Output
.
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide
).
).
Precise Stop Counter Value ).
Terminal