Danfoss VLT AutomationDrive FC 300 Programming Manual page 148

FC 300 Programming Guide
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
8-51 Quick Stop Select
Select control of the Quick Stop function via the terminals (digital input) and/or via the bus.
Option:
[0] Digital Input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
8-52 DC Brake Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
8-53 Start Select
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] * Logic OR
NB!
This parameter is active only when par. 8-01
Activates Start command via the fieldbus/serial communication port OR via one of the digital inputs.
Control Site is set to [0]
Function:
Control Site is set to [0]
Function:
Select control of the DC brake via the terminals (digital input) and/or via the fieldbus.
Activates Start command via a digital input.
Activates Start command via the serial communication port or fieldbus option.
Activates Start command via the fieldbus/serial communication port, AND additionally via one of the
digital inputs.
Activates Start command via the fieldbus/serial communication port OR via one of the digital inputs.
Control Site
is set to [0]
Function:
Select control of the frequency converter start function via the terminals (digital input) and/or via
the fieldbus.
Activates Start command via a digital input.
Activates Start command via the serial communication port or fieldbus option.
Activates Start command via the fieldbus/serial communication port, AND additionally via one of the
digital inputs.
Activates Start command via the fieldbus/serial communication port OR via one of the digital inputs.
Control Site is set to [0]
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
3 Parameter descriptions
Digital and control word .
Digital and control word .
Digital and control word
.
Digital and control word .
3
147