Danfoss VLT AutomationDrive FC 300 Programming Manual page 229

3 Parameter descriptions
30-81 Brake Resistor (ohm)
Range:
Application [Application dependant]
dependent*
30-83 Speed PID Proportional Gain
3
Range:
Application [0.0000 - 1.0000 ]
dependent*
30-84 Process PID Proportional Gain
Range:
0.100* [0.000 - 10.000 ]
228
Function:
Set the brake resistor value in Ohms. This value is used for monitoring the power to the brake
Brake Power Monitoring
resistor in par. 2-13
dynamic brake.
Function:
Enter the speed controller proportional gain. Quick control is obtained at high amplification. However
if amplification is too great, the process may become unstable.
Function:
Enter the process controller proportional gain. Quick control is obtained at high amplification. How-
ever if amplification is too great, the process may become unstable.
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
FC 300 Programming Guide
. This parameter is only active in drives with an integral