Danfoss VLT AutomationDrive FC 300 Programming Manual page 74

FC 300 Programming Guide
3-04 Reference Function
Option:
[0] * Sum
[1] External/Preset
3.5.3 3-1* References
Parameters for setting up the reference sources.
Select Preset ref. bit 0 / 1 / 2
Select the preset reference(s).
3-10 Preset Reference
Array [8]
Range: 0-7
Range:
0.00 %* [-100.00 - 100.00 %]
Preset ref. bit
Preset ref. 0
Preset ref. 1
Preset ref. 2
Preset ref. 3
Preset ref. 4
Preset ref. 5
Preset ref. 6
Preset ref. 7
3-11 Jog Speed [Hz]
Range:
Application [Application dependant]
dependent*
Function:
Sums both external and preset reference sources.
Use either the preset or the external reference source.
Shift between external and preset via a command on a digital input.
[16], [17] or [18] for the corresponding digital inputs in par. group 5-1*.
Function:
Enter up to eight different preset references (0-7) in this parameter, using array programming. The
preset reference is stated as a percentage of the value Ref
Ref different from 0 (par. 3-02
MIN
calculated as a percentage of the full reference range, i.e. on the basis of the difference between
Ref and Ref . Afterwards, the value is added to Ref
MAX MIN
Preset ref. bit 0 / 1 / 2 [16], [17] or [18] for the corresponding digital inputs in parameter group
5-1*.
2
0
0
0
0
1
1
1
1
Function:
The jog speed is a fixed output speed at which the frequency converter is running when the jog
function is activated.
Jog Ramp Time
See also par. 3-80 .
®
MG.33.M8.02 - VLT is a registered Danfoss trademark
3 Parameter descriptions
(par. 3-03
MAX
Minimum Reference
) is programmed, the preset reference is
. When using preset references, select
MIN
1
0
0
1
1
0
0
1
1
3
Maximum Reference ) If a
0
0
1
0
1
0
1
0
1
73