Table 4-16 Gcd-4Lc( )/Gcd-8Lc( ) Led Indications; Table 4-17 Gcd-4Lc( )/Gcd-8Lc( ) Rj-61 Cable Connector Pin-Outs - NEC Univerge SV9100 System Hardware Manual

Table 4-16 GCD-4LC( )/GCD-8LC( ) LED Indications

LED Indication
Live LED
Busy LED (Red)
(Green)
On On
Flash (1s) On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash 100ms
(On/Off)
4-42
4.3.3 LED Indications
LED indications for the GCD-4LC( )/GCD-8LC( ) are listed in
GCD-4LC( )/GCD-8LC( ) LED
associated function and LED and Operational status.
Refer to Figure 4-16 GCD-4LC( )/GCD-8LC( ) Blade on page 4-40
location of the LEDs on the blades.
Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
4.3.4 Connectors
Table 4-17 GCD-4LC( )/GCD-8LC( ) RJ-61 Cable Connector Pin-Outs on
page 4-43 show the pin-outs for the RJ-61 connector.
4LC( )/GCD-8LC( ) Blade on page 4-40
connectors and the pin number locations on the GCD-4LC( )/GCD-8LC( )
blades.
Indications. Each LED is listed with its
Remarks
–
When you exceed the system
capacity.
When the main software version is
not matched.
–
–
–
–
–
–
Figure 4-16 GCD-
shows the location of the
Installing the SV9100 Blades
Issue 2.0
Table 4-16
for the