Table 4-18 Gpz-4Lc( )/Gpz-8Lc( ) Rj-61 Cable Connector Pin-Outs; Installation - NEC Univerge SV9100 System Hardware Manual
Hide thumbs
Also See for Univerge SV9100:
- Features and specifications (1403 pages) ,
- Programming manual (954 pages) ,
- Manual (766 pages)
Table of Contents
Advertisement
Issue 2.0
SV9100 System Hardware Manual
Each J3 (GPZ-4LC( )/GPZ-8LC( )) or J4 (GPZ-8LC( ) only) connector
provides connection to four analog station ports and is not polarity sensitive.
The GPZ-8LC( ) consumes eight ports ranging between ports 1~896
(remember that the GCD-8LC( ) consumes eight ports).
Refer to the following tables for maximum upgrade capacity of the GPZ-
4LC( )/GPZ-8LC( ) SLI daughter board:
Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System
Capacities – Blades on page 2-12
Table 2-7 SV9100 Maximum 9.5" Base and Expansion System
Capacities – Blades on page 2-14
4.4.2
Installation
CAUTION
This daughter board can be installed on the GCD-4LC( ) or GCD-8LC( )
blade.
To install the GPZ-4LC( )/GPZ-8LC( )
1.
Four plastic spacers are Included with the GPZ-4LC( )/GPZ-8LC( ).
Install the plastic spacers on either the GCD-4LC( )/GCD-8LC( ).
Make sure to attach the spacers so that they extend out on the side of
the daughter board which has the CN1 connector. Refer to
4-17 Installing the GPZ-4LC( )/GPZ-8LC( ) Daughter Board on page
4-44.
2.
Position the GPZ-4LC( )/GPZ-8LC( ) J1 connector over the J2
connector on the GCD-4LC( )/GCD-8LC( ) blade. Press the blade and
board together, ensuring the plastic spacers lock in place. Refer to
Figure 4-17 Installing the GPZ-4LC( )/GPZ-8LC( ) Daughter Board on
page
4-44.
3.
Install the GCD-4LC( )/GCD-8LC( ) blade in the slot in the chassis.
4.4.3
Connectors
Table 4-18 GPZ-4LC( )/GPZ-8LC( ) RJ-61 Cable Connector Pin-Outs on
page 4-46
show the pin-outs for the RJ-61 connector.
the GPZ-4LC( )/GPZ-8LC( ) Daughter Board on page 4-44
location of the connectors on the GPZ-4LC( )/GPZ-8LC( ) daughter boards.
When connecting a fax machine or analog modem, make
❍
sure to set Program 15-03-03 to 1 (special terminal) to
avoid communication problems.
❍
The GCD-4LC( )/GCD-8LC( ) blade and the GPZ-4LC( )/
GPZ-8LC( ) daughter board are categorized as TNV2. With
this designation, off-premise wiring is not acceptable. Any
cabling to these blades or daughter boards must be in the
building – no outside cabling is permitted.
❍
Branch connection is not acceptable.
:
Figure
Figure 4-17 Installing
shows the
4-45
Advertisement
Table of Contents
