7-22
2.
If a line cord was not previously connected to the PGDAD, complete Steps
3~6. Otherwise, skip to Step 7.
3.
Install a modular jack for each PGDAD. For each module, run one-pair 24
AWG station cable from the cross-connect block to a modular jack. Ground
the unused pair.
4.
Terminate the extension leads to GRN/RED of the modular jack. Terminate
the unused leads to the jack.
5.
Install bridging clips as required.
6.
Plug a modular line cord from the mod jack to the CN1 connector on the
PGDAD.
7.
Connect an RCA jack to the audio output(s) on the back of the
PGDAD.
8.
The opposite end of this cable is connected to the external music source
either directly or by connecting to the cross-connect block where the music
source is connected.
Figure 7-16 CPRU Connections
Installing SV9100 Optional Equipment
Issue 2.0