Figure 3-100 Stand Mount 9.5" Chassis - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual
6. Turn the 9.5 inch chassis over and place in the location to be installed.

Figure 3-100 Stand Mount 9.5" Chassis

Secure the 9.5" assembly to a flat surface with the four screws supplied.
7.
To prevent possible damage to the 19" chassis due to falling, NEC
recommends screws be installed in the stand mount brackets as soon
as possible.
WARNING
8. Connect grounding wire to chassis. Refer to Chapter 4 paragraph
Installing the 9.5" Gateway (CHS2UG GW) and Base (CHS2UG B) Chassis
on page 3-22 for complete details on grounding the system.
9. Refer to 3.3.5 Install AC Power Cords on 19" Chassis on page 3-20
installation of the power cord or, Chapter 6 paragraph
Safety Precautions on page 4-4
2.1 Installation and
for installation of blades.
3.4
for
3-81