Connector Pin-Out On The Gpz-Bs10/Gpz-Bs11; Figure 3-36 Gpz-Bs10 Components; Figure 3-37 Chs2Ug B Expansion Bay; Table 3-4 Gpz-Bs10/Gpz-Bs11 Connector Pin-Out - NEC Univerge SV9100 System Hardware Manual

3-30
3.5.2.1

Connector Pin-Out on the GPZ-BS10/GPZ-BS11

Table 3-4 GPZ-BS10/GPZ-BS11 Connector Pin-Out

3.5.2.2 Install the GPZ-BS10 Expansion Base Blade in the
CHS2UG B Controlling Chassis

Figure 3-36 GPZ-BS10 Components

WARNING
1.
2.
3.
RJ-61 Cable Connector
GPZ-BS10 – CN2, CN3, CN 4
GPZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with the power
on.
Ensure the chassis is powered down.
Locate the door positioned on the left end (expansion bay)
of the Controlling Chassis.
From the right side of the door, pinch the Door Clip and pull
the cover outward to expose the expansion bay (refer to
Figure 3-37 CHS2UG B Expansion Bay on page
Issue 2.0
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
3-31).
Installing the SV9100 Chassis