Figure 5-100 Securing The Dcl-60-1/Dcz-60-2 Console With Screws; Figure 5-101 Serial Cable Installed - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Secure the DCL-60-1/DCZ-60-2 CONSOLE to the bracket

with the two screws provided.

Figure 5-100 Securing the DCL-60-1/DCZ-60-2 CONSOLE with

Open the small door covering the side option connectors by

pulling the cover latch toward you (refer to

Serial Cable

Installed, ITL, DT700 only).

Connect the cable from the DCL-60-1/DCZ-60-2 CONSOLE

to the Side Option Connector on the multiline terminal and

close the cover (DT700/DT800 only).

Set the tilt leg on the multiline terminal to the desired height.

Installing DT Series Digital and IP Multiline Terminals

Figure 5-101