Figure 3-64 Chassis Installed (9.5" Chassis) - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual
14. Lift the shaft and close the 9.5 inch chassis. To secure the chassis to
the wall, tighten the knurled screws located on the upper and lower
brackets.

Figure 3-64 Chassis Installed (9.5" Chassis)

15. Connect grounding wire to chassis. Refer to Chapter 4 paragraph
Installing the 9.5" Base (CHS2UG B) and Expansion (CHS2UG E)
Chassis on page 3-24
16. Refer to 3.5.5 Install AC Power Cord on 9.5" Base and Expansion
Chassis on page 3-37
paragraph
installation of blades.
for complete details on grounding the system.
for installation of the power cord or, Chapter 6
2.1 Installation and Safety Precautions on page 4-4
3.5
for
3-53