NEC Univerge SV9100 System Hardware Manual page 481

Hide thumbs Also See for Univerge SV9100:

Table of Contents

SV9100 System Hardware Manual

Strip one end of the cable to be connected to the control relay or door box

so that approximately 1/4" (8mm) of bare wire is exposed.

Insert the cable into the proper CN4 or CN5 location while holding down the

lock button (holding down this lock button is easiest with a flat-head

screwdriver). Once the cable is in place, release the lock button.

Refer to the specific function being connected for more detail on

PGDAD connections.