11.5.2 Using The Psa-L Adapter - NEC Univerge SV9100 System Hardware Manual

7-48

11.5.2 Using the PSA-L Adapter

WARNING
1.
Placing Calls:
When the PSTN line is activated either manually by the switch or due
to a power failure, use the dial pad buttons (0-9, *, #) to place an
outside call. Use the Vol
levels.
Other than receiving calls, no other multiline terminal function

is available.
2. Answering Calls:
If you receive a call via PSTN during a conversation via LAN,

answer the call by completing the LAN call and placing the
handset back into the cradle. Change the LAN/PSTN Change
Switch to PSTN and then lift the handset to answer the call. If
you change the LAN/PSTN Change Switch to the PSTN
position while talking via LAN, the LAN call is disconnected.
Other than receiving calls, no other terminal function is

available.
3.
Adjusting the Ring Volume
Use the Volume Control Switch located on the PSA-L adapter to
adjust through the three available volume levels.
Other than receiving calls, no other terminal function is

available.
4.
When Power is Restored
The IP multiline terminal restarts and reconnects to the network LAN.
However, if you are on a PSTN call when the power is restored, your
conversation continues until the handset is placed in the cradle. Once
this occurs, the IP terminal restarts and reconnects to the LAN.
Other than receiving calls, no other terminal function is

available.
BEFORE INSTALLING OR REMOVING the PSA-L adapter,
remove the line cord, LAN cable, and then AC adapter from the
outlet.
 
or to increase or decrease audio
Installing SV9100 Optional Equipment
Issue 2.0