6.2
3-78
Stand Mounting the 9.5" CHS2UG B Chassis
The 9.5" chassis can be stand mounted using the brackets supplied. The following
section describes this procedure.
This bracket is not for use with a combined Base (CHS2UG B) and
Expansion (CHS2UG E) chassis. A combined Base and Expansion
chassis should only be rack or wall mounted.
WARNING
Using the chassis stand unit (stand/floor mounting), will increase the
height of the chassis by 50 mm.
NOTE
1.
Position the 9.5" Base Chassis so that the EXIFU slot is on top.
2.
Align the Base unit with holes A, B, C and D on the lower side of the
CHS2UG B chassis. Attach with the provided M4 x 14 screws.
Figure 3-95 Attaching the Base Stand
Issue 2.0
Installing the SV9100 Chassis