Switch Settings; Led Indications - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
S5 - Load Switch
SW4-1
SW4-2
SW4-3
SW4-4
S6
System Hardware Manual
3.1.3

Switch Settings

Refer to Table 4-6 GCD-CP10 Switch Settings
system reset and with system power on.
Blade Layout on page 4-16
the GCD-CP10 blade.
Table 4-6 GCD-CP10 Switch Settings
USB Memory Status
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Switch
When USB Memory is
installed:
When an unauthorized USB
device is installed:
Table 4-7 GCD-CP10 Switch 6 Settings
Configuration
ON
OFF
OFF
ON
SENSE switch
3.1.4

LED Indications

The LEDs on the CPU indicate the following:
for system restart/
Figure 4-3 GCD-CP10
shows the location of the SW1 switch on
Operation
Cold Start occurs.
USB Memory contents loaded.
System does not start and an "Illegal
USB device is connected" alarm is
recorded.
Note
Not Used
Test Mode
ON = Test Mode
OFF = Normal
RS232C Select
ON = Use
OFF = Not Used
Reset Configuration
ON = Normal
OFF = ICE Mode
Not Used
Issue 1.2
4 - 23