Issue 2.0
SV9100 System Hardware Manual
3.1.2
Installation
Each SV9100 system must have the GCD-CP10 installed in Slot 1 of the
Controlling Chassis.
CAUTION
3.1.2.1
Battery Installation and Removal
Battery Installation
WARNING
1.
Figure 4-8 GCD-CP10 Battery Installation
IMPORTANT CONSIDERATIONS
The chassis power must be off when installing or removing
❍
the GCD-CP10.
❍
After removing a previously installed GCD-CP10, handle
the blade, carefully, from the edges. If certain solder points/
resistors are touched on the back of the blade, some RAM/
temporary memory may be lost (e.g., time, date, user-defined
settings, etc.)
❍
Do not remove the CPU chip installed on the GCD-CP10
blade.
❍
Keep away from open flame. Avoid excessive
heat.
❍
Verify polarity (+, -) when installing battery.
❍
Do not short the electrodes (+, -) with metals
such as wire.
❍
Do not puncture, crush or solder the battery.
Install the battery (CR2032 3.0V coin-type lithium battery)
onto the GCD-CP10. The polarity + symbol must be on top
as illustrated in
Figure 4-8 GCD-CP10 Battery
Installation.
4-19