Issue 2.0
SV9100 System Hardware Manual
Two USB 1.0 ports for USB keyboard support, database backup and
software upgrades
One 15-pin VGA connector for VHA monitor support
6.1.2
Installation
Only one GCD-VM00 can be installed per system.
WARNING
1.
Wear a grounding strap while handling the GCD-VM00 and lay it on a
flat workspace.
2.
Mount the CR-2032 battery with the + side up in the BATT slot on the
GCD-VM00 (refer to
Figure 4-31 Install the CR-2032 Battery
3.
To Install the SO-DIMM memory on the GCD-VM00 blade, insert the
end with the brass connectors into the CN14 1 slot first.
4.
Push the other end down until the lock on both sides locks into place
(refer to
Handle the CF drive carefully. To prevent damage, do not
❍
drop the drive or apply pressure to it.
❍
This unit makes extensive use of CMOS technology and is
very susceptible to static; extreme care must be taken to
avoid static discharge when handling
Figure 4-31 Install the CR-2032
Figure 4-32 Install the SO-DIMM Memory on page
Battery).
4-82).
4-81