Figure 3-30 Installing The Expansion Bracket; Figure 3-31 Remove Expansion Chassis Cover - NEC Univerge SV9100 System Hardware Manual

3-26
3. Match the Joint Bracket with screw holes A, B, C and D on the side of
the Base Chassis (refer to
Bracket), and install with four M4 x 14 screws.

Figure 3-30 Installing the Expansion Bracket

4. From the Expansion Chassis, loosen and remove screws d and e
from the top cover (refer to
Cover). Slide cover toward rear of chassis and lift to remove.

Figure 3-31 Remove Expansion Chassis Cover

Figure 3-30 Installing the Expansion
Figure 3-31 Remove Expansion Chassis
Installing the SV9100 Chassis
Issue 2.0