Wall Mounting The Multiline Terminal; Figure 5-74 Bundling The Line Cord; Figure 5-75 Plugging In Line Cord - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
5-76
4.12.1.2

Wall Mounting the Multiline Terminal

1. Plug line cord in the wall receptacle. Leave about eight
inches of cord and bundle the rest as shown in
Bundling the Line

Figure 5-74 Bundling the Line Cord

2. Ensure the Tilt Legs are in the flat (unused position).
3. Plug the line cord into the multiline terminal as illustrated in
Figure 5-75 Plugging in Line

Figure 5-75 Plugging in Line Cord

4. Align the two holes on the back of the multiline terminal with
the two screws on the wall plate and slide downward (refer
to Figure 5-76 Mount Multiline Terminal Wall on Wall Plate
on page
Installing DT Series Digital and IP Multiline Terminals
Cord.
Cord.
5-77).
Figure 5-74