Connecting The Line Cord; Line Cord Connection Dt300; Figure 5-34 Installing The Line Cord (Dt300) - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
5-46
Figure 5-33 Installing the Handset (DT400)
4.1.2

Connecting the Line Cord

Confirm the location of the line connector
terminal. Then, connect the line cord to the multiline terminal using the
steps shown below.
4.1.2.1

Line Cord Connection DT300

1.

Figure 5-34 Installing the Line Cord (DT300)

on the bottom of the multiline
Install the modular plug of the Line Cord into the Line
Connector at the back of terminal. Push until it snaps into
place. Refer to Figure 5-34 Installing the Line Cord
Installing DT Series Digital and IP Multiline Terminals
(DT300).