Wall Mounting The Bluetooth Cradle; Figure 6-13 Wall Mount Spacing Guide Bch-L (Bk) Unit - NEC Univerge SV9100 System Hardware Manual

6-12
2.4.2

Wall Mounting the Bluetooth Cradle

WARNING
Clearances required for installing the Bluetooth cradle are shown below.
Avoid mounting the cradle on a plaster-board wall, but before mounting the
cradle on a wall, check that the wall can support the weight of the telephone
and withstand the load from pulling the telephone during operation.

Figure 6-13 Wall Mount Spacing Guide BCH-L (BK) UNIT

1. Attach two wood screws to the wall.
 Keep a clearance of about 0.08" (2mm) between each wood screw
and the wall (refer to
page
To prevent possible damage to the BCH-L (BK) UNIT due to
falling, NEC recommends installing the unit in a firm
position so it cannot fall because of its own weight.
Figure 6-14 Installing Wood Screws on
6-13).
Installing SV9100 Cordless Telephones
Issue 2.0