Figure 4-15 Gpz-8Dlcb Daughter Board; Table 4-15 Gpz-8Dlcb Rj-61 Cable Connector Pin-Outs; Installation - NEC Univerge SV9100 System Hardware Manual

4-38
Refer to the following tables for maximum upgrade capacities of the
GPZ-8DLCB daughter board:
Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System

Capacities – Blades on page 2-12
Table 2-7 SV9100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-14
4.2.2

Installation

The GPZ-8DLCB is installed on the GCD-8DLCA. To install:
1. Connect the GPZ-8DLCB to the CN2 connector on the GCD-8DLCA
blade. Refer to
page 4-33
2. Install the GCD-8DLCA into a slot.
3. Each CNx01 connector (CN101, CN201, CN301, CN401) is used to
connect up to four digital extensions.
4.2.3 GPZ-8DLCB Daughter Board Cable Connection
The GPZ-8DLCB blade has connections for CN301 and CN401. Refer to
Figure 4-14 GCD-8DLCA/GCD-16DLCA Blade on page 4-33
locations.
The following tables show the cable connections of the two RJ-61
connectors on the GPZ-8DLCB.

Table 4-15 GPZ-8DLCB RJ-61 Cable Connector Pin-Outs

Figure 4-14 GCD-8DLCA/GCD-16DLCA Blade on
for the location of the connectors on the blade.
RJ-61 Cable Connector
CN301 (ports 9~12)
Pin No.
1 (T4) Tip for port 12
2 (T3) Tip for port 11
3
(T2) Tip for port 10
4 (R1) Ring for port 9
5 (T1) Tip for port 9
6 (R2) Ring for port 10
7 (R3) Ring for port 11
8
(R4) Ring for port 12
Issue 2.0
for connector
Connection
Installing the SV9100 Blades