7-46
16.
Attach the analog trunk cable and the handset cable. Refer to
7-36 PSA-L UNIT Connections on page
17.
Install the legs, pushing upwards until both locks snap into place.
18.
Return tilt leg to desired position.
19.
Place the multiline terminal numbered keypad up.
20.
Connect the Line cord, the PSTN cable and the Handset cord (if
used).
21.
Remove both plastic panels from the front of the multiline terminal.
Figure 7-45 Remove Plastic Panels
22.
Pull tab down and lift out the numbered keypad panel.
Figure 7-46 Remove Numbered Keypad
7-41.
Installing SV9100 Optional Equipment
Issue 2.0
Figure