Figure 3-65 Wall Mount Spacing Guide (Base And Expansion Chassis) - NEC Univerge SV9100 System Hardware Manual

Figure 3-65 Wall Mount Spacing Guide (Base and Expansion Chassis)

3-54
4.2.1.1 Wall Mounting the 9.5" Base (CHS2UG B) and
Expansion (CHS2UG E) Chassis
1. Use the template shown in
Guide (Base and Expansion Chassis)
before drilling.
TIP
2. Mark and drill four holes marked A, B, C and D.
3. Mount Anchor bolts (locally procured), in holes A and B
drilled in step 2.

Because the bracket (upper) will be hooked onto the head
of the anchor bolts, allow the head to protrude
approximately 0.14 to 15 in (3.5 to 4.0mm) from the wall
(refer to
Chassis) on page
Figure 3-65 Wall Mount Spacing
Plywood should first be installed on the wall where
the chassis will be positioned. This allows secure
anchoring of the screws, which support the weight
of the chassis.
(Figure 3-66 Anchor Bolt from Wall (9.5"
3-55).
Installing the SV9100 Chassis
Issue 2.0
for required spacing