7-50
3.
Lower the tilt leg to the first position (refer to
Leg from Leg
Support).
Figure 7-50 Separate Tilt Leg from Leg Support
Tilt Leg
4.
Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5.
Lay the tilt leg and the leg support flat.
6.
Press the two tabs locking the legs to the multiline terminal and pull
the legs toward you, lifting to remove (refer to
Legs From Multiline
Figure 7-51 Remove Legs From Multiline Terminal
Figure 7-50 Separate Tilt
Terminal).
Installing SV9100 Optional Equipment
Issue 2.0
Stoppers
Figure 7-51 Remove