Table 4-11 Iple Daughter Board Led Indications; Table 4-12 Iple Daughter Board Led Cn1 Transmit/Receive Data Indications - NEC Univerge SV9100 System Hardware Manual

Issue 2.0
SV9100 System Hardware Manual
3.2.4 LED Indications
LED indications for the GPZ-IPLE Daughter Board are indicated in
4-11 IPLE Daughter Board LED Indications on page
listed with its associated function and LED and Operational status. Refer to
Figure 4-7 GCD-CP10 Blade with Daughter Boards Installed on page 4-16
for the location of the LEDs on the blades.

Table 4-11 IPLE Daughter Board LED Indications

LED
Link 10 10 Base-TX link speed indicator
(D103)
LINK 100 100 Base-T link speed indicator
(D102)
LINK 1000 1000 Base-T link speed indicator
(D101)
ACT Link activity or data transmission
(D100) and reception
Table 4-12 IPLE Daughter Board LED CN1 Transmit/Receive Data
Indications
CN1.

Table 4-12 IPLE Daughter Board LED CN1 Transmit/Receive Data Indications

ACT Link1000
Off Off
Off On
On
On
On Off
Blinking one by one
Flash

The IPLE only supports full-duplex transmission.
Function
Status
On Red
On Red
On Yellow 1000 Base-T link up
On Green
shows the LED indication when transmitting or receiving data on
LED
Link100 Link10
Flash Flash Internal Error (Hardware Error)
Flash Flash
Flash Flash
Flash Flash State of half-duplex transmission (Not
supported) Change HUB etc. to
full-duplex transmission.
The firmware is being updated.
4-29. Each LED is
LED
Operation Status
10 Base-TX link up
100 Base-T link up
LED lights when link up is
completed. LED flashes
when data is transmitting
or receiving.
Operation Status
Table
4-29