Connector Pin-Out On The Gpz-Bs10/Gpz-Bs11; Install The Gpz-Bs10 Expansion Base Blade In The Chs2Ug Controlling Chassis; Figure 3-6 Gpz-Bs10 Components; Table 3-3 Gpz-Bs10/Gpz-Bs11 Connector Pin-Out - NEC Univerge SV9100 System Hardware Manual

3-10
3.3.2.1

Connector Pin-Out on the GPZ-BS10/GPZ-BS11

3.3.2.2 Install the GPZ-BS10 Expansion Base Blade in the
CHS2UG Controlling Chassis

Figure 3-6 GPZ-BS10 Components

WARNING
1.
2.

Table 3-3 GPZ-BS10/GPZ-BS11 Connector Pin-Out

RJ-61 Cable Connector
GPZ-BS10 – CN2, CN3, CN 4
GPZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with the
power on.
Ensure the chassis is powered down.
Locate the door positioned on the left end (expansion bay)
of the Controlling Chassis (refer to
Expansion Bay in Controlling Chassis on page
Issue 2.0
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
Figure 3-7 GPZ-BS10
3-11).
Installing the SV9100 Chassis