Installing The 19" Controlling Chassis; Figure 3-4 Installing The Gcd-Cp10 Blade; Figure 3-5 Gcd-Cp10 Blade Installed - NEC Univerge SV9100 System Hardware Manual
Hide thumbs
Also See for Univerge SV9100:
- Features and specifications (1403 pages) ,
- Programming manual (954 pages) ,
- Manual (766 pages)
Table of Contents
Advertisement
3-8
3.3.1
Installing the 19" Controlling Chassis
1.
Ensure the chassis is powered down.
WARNING
2.
Align the GCD-CP10 blade with the Slot 1 guides of the Controlling
Chassis.
Figure 3-3 19" Controlling Chassis – Guides Slot 1
3.
Slide the GCD-CP10 blade into the chassis until resistance (back
plane) is felt.
Figure 3-4 Installing the GCD-CP10 Blade
4.
Gently push until the blade seats. Tighten the two retaining screws on
front of the blade.
Figure 3-5 GCD-CP10 Blade Installed
Do not remove or install blades with the power on.
Issue 2.0
Installing the SV9100 Chassis
Advertisement
Table of Contents
