Led Indicators; Pcb Buttons - NEC Aspire 16CNFU Manual

LED Indicators

LED
DS1 Channel Status (Back of PCB)
DS2 Channel Status (Back of PCB)
DS3 Channel Status (Back of PCB)
DS4 Channel Status (Back of PCB)
DS5 Channel Status (Back of PCB)
DS6 Channel Status (Back of PCB)
DS7 Channel Status (Back of PCB)
DS8 Channel Status (Back of PCB)
DS9 LIVE
DS10 CF BUSY
LED 3 (DS13) Conference Status
LED 2 (DS12) Insertion Status (Back of PCB)
LED 1 (DS11) Boot Status (Back of PCB)

PCB Buttons

The 16CNFU PCB has the following buttons.
● PCB Reset Button SW1
To perform a hard reset (reset the PCB to factory defaults), pull the PCB from the system cabinet, hold
the SW1 button in, reinsert the PCB, and continue holding the button for approximately 5 seconds. Wait
approximately 90 seconds for the PCB to Þnish resetting.
● Reset Button SW3
This switch allows the technician to reset the 16CNFU PCB. Pressing the Reset button while the PCB
is installed and operating will perform a soft reset of the PCB (resets the PCB, but retains the current
settings).
Aspire Conference Bridge Manual
Chapter 1 : Aspire Conference Bridge PCB
Table 1: 16CNFU PCB LED Indications
Description
(Back of PCB)
On
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
When any Conference
circuit in use
PCB Active
Flash Access
Conference Initialized
Insertion Complete
Boot Complete
PCB Description
Off
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Not Currently Used
Off when no Conference
circuits in use
PCB Inactive
No Flash Access
Conference Not Initialized
Insertion Not Complete
Boot Incomplete
◆ 3