Suzuki Wagon R Manual page 3667

4A5-8 FRONT DRIVE SHAFT (Z12XEP ENGINE MODEL)
b) Clamp drive shaft in soft jawed vise, and then open retain-
ing ring using special tool and tap DOJ of drive shaft (1)
using plastic hammer until retaining ring no longer engages
in groove of shaft.
Special tool
(A): 09900-06107
c) Remove retaining ring (2) with DOJ (1) from housing (3) if
necessary.
3) Remove differential side boot small band, and then pull out
differential side boot from shaft.
4) Pull out damper through shaft.
5) Remove wheel side boot big band (1) as follows.
For boot big band without joint
a) Cut boot big band using a iron saw or a nipper with care not
to damage wheel side joint housing.
For boot big band with joint
a) Remove boot big band by using flat end rod or the like.
6) Remove wheel side boot small band, and then pull out wheel
side boot from shaft.
[A]: For boot big band without joint
[B]: For boot big band with joint