Suzuki Wagon R Manual page 3751

6-4-70 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T05 Check: Short to Voltage of Signal Circuit
• Ignition OFF
• Remove fused jumper wire
• Disconnect wiring harness connector from:
ECM (Wiring Harness Connector C36)
&
Radiator fan relay
• Ignition ON
• Measure voltage between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-5
&
Ground
Yes: T06
T06 Check: Short to Voltage of Signal Circuit
• Measure voltage between the following terminals:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-6
&
Ground
Yes: T07
T07 Check: Interruption of Signal Circuit
• Ignition OFF
• Measure resistance between the following terminals:
ECM - Wiring harness connector (wiring harness side) terminal
C36-23
&
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-6
Yes: T08
T08 Check: Component
• Connect wiring harness connector to:
ECM
• Ignition ON
• Connect fused jumper wire to:
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-2
&
TP sensor - Wiring harness connector (wiring harness side) termi-
nal C25-6
• Scan Tool Data List Parameter
TP Sensor 1 Volt
Yes: T09
Work Order Description Nominal Value
less than 0.3 V
No: E11
less than 0.3 V
No: E10
less than 5 Ω
No: E09
less than 0.3 V
No: E08