Suzuki Wagon R Manual page 4031

7C5-10 CLUTCH (Z12XEP ENGINE MODEL)
1, "A"
2) Aligning clutch disc to flywheel center using special tool,
install clutch cover (1) and bolts. Then tighten bolts to speci-
fication.
NOTE:
• While tightening clutch cover bolts, compress clutch
disc with special tool (B) by hand so that disc cen-
tered.
• Tighten cover bolts little by little evenly in diagonal
order.
Special tool
(A): 09924-17811
(B): 09923-36320
Tightening torque
Clutch cover bolt (a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
3) Slightly apply grease to cluster gear (1), then join transaxle
assembly with engine referring to "Transaxle unit Dismount-
ing and Remounting" in Section 7A5.
"A": Lubricating compound 99000-84E40
NOTE:
When inserting transaxle cluster gear to clutch disc, turn
crankshaft little by little to match splines.
Clutch Cover and Clutch Disc and Flywheel
Inspection
Clutch cover
1) Check diaphragm spring (1) for abnormal wear or damage.
2) Inspect pressure plate (2) for wear or heat spots.
3) If abnormality is found, replace clutch cover. Do not disas-
semble it into diaphragm spring (1) and pressure plate (2).