Suzuki Wagon R Manual page 3724

Result
E07 • Defective component:
Starting motor
or
Ignition switch
E08 • Short circuit to ground between:
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-3
&
Starting motor - Wiring harness connector (wiring harness side) terminal C06-1
E09 • Short circuit to ground between:
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-1
&
Circuit fuse - Input contact
E10 • Short circuit to ground between:
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-2
&
Circuit fuses - Input contact
E11 • Short circuit to ground between:
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-4
&
Circuit fuses - Input contact
E12 • Short circuit to ground between:
Main fuse - Output contact
&
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-5
E13 • If the nominal value is reached during one of the measurements, the component/control module
that has been disconnected immediately before that measurement is defective.
NOTE:
• If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring
to "Procedure after ECM Replacement" in Section 8G3.
• If immobilizer control module is replaced, register fix code (FC) and secret key code
(SKC) to immobilizer control module by performing procedure described in "Procedure
After Immobilizer Control Module Replacement" in Section 8G4.
E14 • Short circuit to ground between:
Circuit fuse - Output contact
&
ECM - Wiring harness connector (wiring harness side) terminal G21-51
&
Wiring harness connector terminals of all components (wiring harness side), which were discon-
nected from the wiring harness during this trouble shooting session
E15 • Circuit interruption between:
Circuit fuse - Output contact
&
ECM - Wiring harness connector (wiring harness side) terminal G21-18
E16 • Circuit interruption between:
Circuit fuse - Output contact
&
Data link connector - Wiring harness connector (wiring harness side) terminal G09-16
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-43
Cause Of Fault