Suzuki Wagon R Manual page 3837

6A4-10 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Cylinder Head Cover Removal and Installa-
tion
Removal
1) Disconnect negative cable at battery.
2) Remove air intake pipe (3).
3) Disconnect wiring trough (1) and preheater hose (2).
4) Remove ignition module referring to "Ignition Module
Removal and Installation" in Section 6F4.
5) Disconnect engine vent hose (4) from cylinder head cover.
6) Loosen cylinder head cover bolts gradually in symmetrical
order starting from the outside inward.
7) Remove cylinder head cover with cylinder head cover gas-
ket.
Installation
1) Remove oil, old sealant and dust from sealing surface on cyl-
inder head and cover.
2) Install new cylinder head cover gasket (2) to cylinder head
cover (1) as shown in figure.
3) Install cylinder head cover as follows.
CAUTION:
Complete installation of cylinder head gasket within 10
minutes after applying sealant.
NOTE:
When installing cylinder head cover, use care so that cyl-
inder head cover gasket will not get out of place or fall
off.
a) Install cylinder head cover to cylinder head.
b) Tighten cylinder head cover bolts gradually in symmetrical
order starting from the center outward until they are tight-
ened to specified torque.
Tightening torque
Cylinder head cover bolt (a): 8 N·m (0.8 kg-m, 6.0 lb-ft)
4) Connect engine vent hose to cylinder head.
5) Install ignition module referring to "Ignition Module Removal
and Installation" in Section 6F4.
6) Connect preheater hose and wiring trough.
7) Install air intake pipe.
8) Connect negative cable at battery.